40261 Media Handler MDH: <Motor name> stepper motor did not reach the sensor it was searching for [<I/O name>] The stepper motor was told to move to a specific location while waiting for a sensor, or sensors, to change to specific states. This error indicates that the stepper motor reached the end of its command without toggling the sensor, or sensors to the expected states. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Broken or faulty sensor Stepper motor has lost steps so is not where it should be Motor name - This is the name of the stepper motor. I/O name - This is the standard firmware name of the sensor. 12-Sep-2005 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:23 2008 PST